Seaport i-Visor LS Pro MAG: On-Set Laptop Sun Hood Guide

Quick answer

The Seaport i-Visor LS Pro MAG Laptop Case with Sun Hood lets you shield your laptop from glare and heat on outdoor shoots. Follow these steps to attach and adjust the sun hood for a clear view.

Setting up the Seaport i-Visor LS Pro MAG Sun Hood

1. 1. Attach the sun hood to the tray: Place the i-Visor On Set Laptop Sunhood over the front of the LS Pro MAG tray. Align the hook-and-loop fastener strips on the hood with the corresponding loops on the tray. Press firmly along the entire length to secure. Common mistake: not pressing the full length of the fastener, leaving gaps that let light in.
2. 2. Adjust the hood tilt: The sun hood has an adjustable tilt mechanism. Gently push or pull the top edge of the hood to angle it toward or away from you until glare is minimized and the screen is clearly visible. Checkpoint: tilt too far forward may block the screen top; tilt too far back may not block overhead light.
3. 3. Route cables through the side ports: The hood has side access openings for cables. Feed your laptop charger, USB or HDMI cables through these ports before connecting them to your laptop. This keeps the hood sealed against light while allowing full connectivity. Common mistake: routing cables after attaching the hood can force you to lift the hood, breaking the light seal.
4. 4. Secure the laptop inside the case: Open the LS Pro MAG case and place your laptop inside. Use the built-in laptop safety strap to hold it firmly in place. Close the rugged zippers completely before moving the case. Checkpoint: forgetting the safety strap can let the laptop shift during transport.
5. 5. Mount the case on a tripod or stand: The LS Pro MAG has a replaceable 3/8"-16 tripod mount on the bottom. Screw it onto a compatible tripod or stand head. Tighten securely. The case now acts as a stable workstation with the sun hood in place. Common mistake: overtightening can strip the mount; hand-tighten plus a quarter turn is enough.

Product facts

• Seaport i-Visor LS Pro MAG Laptop Case with Sun Hood: Ballistic Weaved Nylon Magnesium Alloy Skeleton, Side Access Ports, Replaceable 3/8"-16 Tripod Mount, Passive Flow Through Cooling System, Built-In Laptop Safety Strap, Rugged Zippers, Large Front Pockets The magnesium alloy skeleton protects your laptop during transport, while the tripod mount lets you attach the case to a stand for easy viewing on set.

  

• i-Visor On Set Laptop Sunhood: Shield Laptops/Field Monitors from Glare, Protect Your Gear from Heat, Matte Silver Fabric Exterior, Front Hook and Loop Fastener Attachment, Side Access for Cables, Adjustable Hood Tilt, Fits the i-Visor Pro MAG Tray The sun hood attaches directly to the LS Pro MAG tray, tilts to your preferred angle, and leaves side ports open for cables—no need to remove the hood to connect peripherals.